Skip to main content

Aw9523bDriver

Struct Aw9523bDriver 

Source
pub struct Aw9523bDriver { /* private fields */ }

Implementations§

Source§

impl Aw9523bDriver

Source

pub fn new(res: Aw9523bResources) -> Self

Source

pub async fn arm_touch_interrupt(&mut self) -> Result<(), Aw9523bError>

Let ONLY the touch line pull INTN low, and clear anything pending.

INTN reaches the ESP32-S3 on GPIO21, so this is what makes a touch end a deep sleep. Two halves, both needed:

  • Mask everything else. The mask defaults to all-enabled, so any input pin changing would assert INTN and wake the board for something that is not a touch.
  • Read both input ports. INTN latches until an input register is read. A sleep entered with it already asserted ends immediately — esp-hal wakes on the level, not on the edge — which reads exactly like a board that refuses to sleep.

Call it immediately before sleeping, not at init: anything that touches the panel in between re-asserts INTN.

Source

pub async fn touch_asserted(&mut self) -> Result<bool, Aw9523bError>

Is the touch line asserted right now? (P1_2 is active-LOW.)

Reading the port also clears INTN, so this doubles as the “is the pad at its wake level?” check a caller needs before sleeping.

Source

pub async fn init(&mut self) -> Result<(), Aw9523bError>

Set LEDMODE to GPIO, configure P1 outputs, set up P0_0 (TOUCH_RST) via RMW.

Source

pub async fn lcd_rst_pulse(&mut self) -> Result<(), Aw9523bError>

Pulse LCD_RST (P1_1) low for ≥10 µs, then wait 120 ms for ILI9342C stabilisation.

Source

pub async fn enable_bus_5v(&mut self) -> Result<(), Aw9523bError>

Enable the M-Bus / Grove 5 V output that powers an attached M5GO bottom’s RGB LEDs on CoreS3 (their supply is the M-Bus 5 V rail, pin 28).

Asserts both BOOST_EN (P1_7, the SY7088 boost) and BUS_OUT_EN (P0_1, the load switch) HIGH — matching M5Unified’s setExtOutput(true).

CALLER GUARD: M5Unified only enables this when a battery is present or USB is absent — enabling the bus output with no battery while on USB contends the shared VBUS rail. The caller must enforce that (see the CoreS3 example). Drives the two pins as push-pull GPIO outputs, latched high (RMW — other bits preserved).

Source

pub async fn touch_rst_pulse(&mut self) -> Result<(), Aw9523bError>

Pulse TOUCH_RST (P0_0) low for 5 ms, then wait 300 ms for FT6336U boot.

Auto Trait Implementations§

§

impl !RefUnwindSafe for Aw9523bDriver

§

impl !Send for Aw9523bDriver

§

impl !Sync for Aw9523bDriver

§

impl !UnwindSafe for Aw9523bDriver

§

impl Freeze for Aw9523bDriver

§

impl PsramSafe for Aw9523bDriver

§

impl Unpin for Aw9523bDriver

§

impl UnsafeUnpin for Aw9523bDriver

Blanket Implementations§

§

impl<T> Any for T
where T: 'static + ?Sized,

§

fn type_id(&self) -> TypeId

Gets the TypeId of self. Read more
Source§

impl<T> Az for T

Source§

fn az<Dst>(self) -> Dst
where T: Cast<Dst>,

Casts the value.
§

impl<T> Borrow<T> for T
where T: ?Sized,

§

fn borrow(&self) -> &T

Immutably borrows from an owned value. Read more
§

impl<T> BorrowMut<T> for T
where T: ?Sized,

§

fn borrow_mut(&mut self) -> &mut T

Mutably borrows from an owned value. Read more
Source§

impl<Src, Dst> CastFrom<Src> for Dst
where Src: Cast<Dst>,

Source§

fn cast_from(src: Src) -> Dst

Casts the value.
§

impl<ST, DT> CastableFrom<ST, Initialized, Initialized> for DT
where ST: ?Sized, DT: ?Sized,

§

impl<ST, DT> CastableFrom<ST, Uninit, Uninit> for DT
where ST: ?Sized, DT: ?Sized,

Source§

impl<T> CheckedAs for T

Source§

fn checked_as<Dst>(self) -> Option<Dst>
where T: CheckedCast<Dst>,

Casts the value.
Source§

impl<Src, Dst> CheckedCastFrom<Src> for Dst
where Src: CheckedCast<Dst>,

Source§

fn checked_cast_from(src: Src) -> Option<Dst>

Casts the value.
§

impl<T> From<T> for T

§

fn from(t: T) -> T

Returns the argument unchanged.

§

impl<T, U> Into<U> for T
where U: From<T>,

§

fn into(self) -> U

Calls U::from(self).

That is, this conversion is whatever the implementation of [From]<T> for U chooses to do.

Source§

impl<Src, Dst> LosslessTryInto<Dst> for Src
where Dst: LosslessTryFrom<Src>,

Source§

fn lossless_try_into(self) -> Option<Dst>

Performs the conversion.
Source§

impl<Src, Dst> LossyInto<Dst> for Src
where Dst: LossyFrom<Src>,

Source§

fn lossy_into(self) -> Dst

Performs the conversion.
Source§

impl<T> OverflowingAs for T

Source§

fn overflowing_as<Dst>(self) -> (Dst, bool)
where T: OverflowingCast<Dst>,

Casts the value.
Source§

impl<Src, Dst> OverflowingCastFrom<Src> for Dst
where Src: OverflowingCast<Dst>,

Source§

fn overflowing_cast_from(src: Src) -> (Dst, bool)

Casts the value.
§

impl<T> Read<Exclusive, BecauseExclusive> for T
where T: ?Sized,

Source§

impl<T> Same for T

Source§

type Output = T

Should always be Self
Source§

impl<T> SaturatingAs for T

Source§

fn saturating_as<Dst>(self) -> Dst
where T: SaturatingCast<Dst>,

Casts the value.
Source§

impl<Src, Dst> SaturatingCastFrom<Src> for Dst
where Src: SaturatingCast<Dst>,

Source§

fn saturating_cast_from(src: Src) -> Dst

Casts the value.
§

impl<T, U> TryFrom<U> for T
where U: Into<T>,

§

type Error = !

The type returned in the event of a conversion error.
§

fn try_from(value: U) -> Result<T, !>

Performs the conversion.
§

impl<T, U> TryInto<U> for T
where U: TryFrom<T>,

§

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.
§

fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>

Performs the conversion.
Source§

impl<T> UnwrappedAs for T

Source§

fn unwrapped_as<Dst>(self) -> Dst
where T: UnwrappedCast<Dst>,

Casts the value.
Source§

impl<Src, Dst> UnwrappedCastFrom<Src> for Dst
where Src: UnwrappedCast<Dst>,

Source§

fn unwrapped_cast_from(src: Src) -> Dst

Casts the value.
Source§

impl<T> WrappingAs for T

Source§

fn wrapping_as<Dst>(self) -> Dst
where T: WrappingCast<Dst>,

Casts the value.
Source§

impl<Src, Dst> WrappingCastFrom<Src> for Dst
where Src: WrappingCast<Dst>,

Source§

fn wrapping_cast_from(src: Src) -> Dst

Casts the value.