Skip to main content

pulse_loop

Function pulse_loop 

Source
pub async fn pulse_loop(
    resources: RpmResources<'static>,
    config: RpmConfig,
    on_pulse_hz: fn(f32),
)
Expand description

Convenience loop: ticker + read_pulse_hz + callback.

on_pulse_hz is invoked only on state transitions, so callers that store into a shared atomic don’t get hammered every 100 ms:

  • each non-zero reading → pulse rate in Hz
  • first zero after non-zero → 0.0 (engine just stopped)
  • [NO_SIGNAL_INTERVALS] zeros → f32::NAN (signal lost)

Both sentinels survive any linear Hz→rpm conversion the caller applies (0.0 * k == 0.0, NAN * k == NAN), so the application does not have to special-case them.

Between the “stopped” and “no signal” transitions the callback is silent, which lets HIL-injected values stick once the rig has been idle long enough.